BIG ASS FANS 0-10 V Manual De Instrucciones página 3

Disconnect power to the fan location before installing and wiring the
fan and 0–10 V module.
If required by your local electrical code, a licensed electrician must
install the fan and 0–10 V module.
Parts included
0–10 V Module
(010446)
Introduction
The 0–10 V module allows analog control inputs from IEC 60929 Annex E
compliant wall controllers or analog inputs from energy management, building,
or home automation systems for fan speed and light dimming commands.
When the 0–10 V module is installed, all other fan controls, including the
remote control and mobile app, are disabled.
1. Install controller(s)
The 0–10 V module requires two separate 0–10 V channels for light and
fan control. For full functionality, two wall controllers are required, or one
automation controller with multiple 0–10 V channels is required. Consult the
instructions included with the wall controller or automation controller you are
installing for product specific wiring diagrams and specifications. Make sure
each controller has a maximum current capacity of 2 mA or higher. Big Ass
Fans recommends Lutron DVTV-xx or DVSCTV-xx (sinking controller).
© 2022 DELTA T LLC
ENGLISH
Power Tap
ALL RIGHTS RESERVED.
Power Supply
Cable
BAF-INST-388-MUL-01 REV. A
(4) Wire Nuts
10/12/2022
1