Ampro TECSHOW STRATUS 1000 Manual De Usuario página 8

Wired Timer Controller (FC-T) Setup
The FC-T wired timer controller allows you to auto-
matically trigger fog output by setting interval and
duration times. LED indicator lights display the ma-
chine and controller's current state. Rotary knobs
set interval time, output, and duration time, while
manual and continuous buttons allow overriding
control.
1. Plug in the fog machine to power.
2. Plug in the wired timer controller to the Manual
Remote Connector socket on the back of the
fog machine. (See the product Overview.)
3. Allow the Stratus 1000 three to four minutes to
heat up before continuing.
FC-T Wired Timer Controller Overview
Uninterrupted Continuous
Mode at Output 7
Wired Timer Controller (FC-T) Operation
The FC-T wired timer controller has three modes of
operation: timer, continuous, and manual.
Timer Mode
To trigger the Stratus 1000 with the timer function,
follow the instructions below:
1. Set the desired output level with the OUTPUT
knob.
2. Set the INTERVAL and DURATION knobs to the
desired positions.
• The INTERVAL knob sets the amount of time
in between bursts of fog.
• The DURATION knob sets the length of time
that the fog machine will run during the
burst.
P. 8
Tecshow Stratus 1000 |
English version
3. Press the <TIMER ON/OFF> latching button. The
LED indicator above the button will light up.
The timer will now run as set by the INTERVAL,
DURATION, and OUTPUT knobs.
4. Press the <TIMER ON/OFF> button again to turn
off the timer.
The <MANUAL> button will override the timer.
Continuous Mode
To trigger the Stratus 1000 to continuously output
fog, follow the instructions below:
1. Set the desired output level with the OUTPUT
knob.
2. Press the <CONTINUOUS> latching button. The
LED indicator above the button will light up.
The fog machine outputs fog until the <CONTIN-
UOUS> button is pressed again.
3. Press the <CONTINUOUS> button again to stop
the fog output.
DO NOT run the product in Continuous mode for
longer than 15 minutes. Continuous mode must be
followed by an equal amount of time without output
(For example: follow 8 minutes of Continuous opera-
tion with 8 minutes of no output). DO NOT trigger the
product to output fog during that time.
• In order for Continuous mode to run uninter-
rupted, without the Hurricane 1000 stopping to
reheat, set the OUTPUT knob no higher than 7.
At Output levels above 7, the fogger will cycle
through intermittent bursts of fog during its
reheating program.
• The duration of Continuous fog output is based
on the capacity of the tank.
• Fluid consumption will be significantly increased
during Continuous mode.