Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE READ THE INSTRUCTIONS CAREFULLY OF THIS MANUAL BEFORE STARTING.
DO NOT HANDLE THE FAN HEATER INTERNALLY.
The texts, photos, colors, figures and data correspond to the current technical level from the moment
they were printed. We reserve the right to modifications motivated by the permanent development
of the technique in our products.
Características Técnicas BP1003
Maximum Power: 2000 W
The rated power: 220 - 240 V ~
Frequency: 50/60 Hz
Insulate class: II
NAME OF HEATER PARTS
EN
1.
Pilot lamp
2.
Thermostat
3.
Commissioning speeds
GENERAL INFORMATION
Before putting the appliance into operation, read the following instructions carefully.
KEEP THIS BROCHURE IN A SAFE PLACE SO YOU CAN SEE IT ANYWHERE MOMENT.
After removing the packaging, make sure that the appliance is in good condition. If in doubt, do not
use the appliance and return it to your dealer.
The packaging is made of plastics, screws, etc. they could prove dangerous for what it would be
advisable to keep them out of the reach of children.
INSTALLATION
This heater does not need installation, because it is a portable device.
Electric heating is not advisable to use in the bathroom.
Place the unit on a flat and unobstructed surface, plug the power cord into a electricity of your
home. Using the upper switch, you can select the heat output (1,000 or 2,000 W) and the unit stop.
When it is in position 0, it is stopped, in the next position (1) will be at 1,000 W of power and in the
next position (2) will be 2,000 W.
By means of the thermostat button it will be activated, completely to the left the heater will be
disconnected, The more you turn to the right the cutting temperature will be higher. Please adjust
the thermostat to obtain an optimal temperature in the room, as well as a high efficiency of saving
consumption, maintaining a pleasant temperature.
This heater is provided with an excess heat safety device, this means that if the thermos fan
accidentally covers the air inlet or outlet, this overheat protector acts, causing the stop, so that the
thermo fan is used again, proceed as follows: Set the switch in position "0" (stopped).
Pull the power cord out of the socket and check that all air inlets and outlets are free.
Wait for the thermo fan to cool down for a period of not less than 10 minutes. Reconnect the power
cord to outlet and put the switch in the heat position (1), check that the thermos fan works perfectly.
OPERATION
Place the thermostat button (right) in a clockwise direction until it reaches its maximum. For the
summer function (ventilation only) turn the knob to the position.
For reduced heat function, set the (right) button to the 1,000w position. For the maximum heat
function, move the (right) button to the 2,000w position. Stop, move the button (left) to position 0.
SECURITY MEASURES
Do not place the appliance under an outlet. Do not place anything on or in front of the heater, as
this reaches high temperatures that could cause deformation or fire of objects.
Do not handle flammable liquids, explosives or gas near the heater.
6
1
3
2
Publicidad
