Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE READ THE INSTRUCTIONS CAREFULLY OF THIS MANUAL BEFORE STARTING.
The texts, photos, colors, fi gures and data correspond to the current technical level from the moment
they were printed. We reserve the right to modifi cations motivated by the permanent development
of the technique in our products.
TECHNICAL SPECIFICATIONS BP1012
Maximum Power: 2000W
The rated power: 220 - 240 V ~
Frequency: 50/50 Hz
Insulate class: II
EN
PARTS DECRIPCIÓN
1.
Pilot lamp
2.
Thermostat
3.
Commissioning speeds
WARNINGS
•
Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools,
etc.
•
Always use the heater in an upright position.
•
Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger
of overheating).
•
The heater must be positioned at least 50cm from furniture or other objects.
•
When the appliance is used in portable version, do not place it up against walls, furniture,
curtains, etc.
•
The appliance must be installed so that the switches and other controls can not be reached by
persons using the bath tub or the shower.
•
This appliance comes with a Y-type connection. Replacement of the feed cable must be
entrusted to a technician only, because such work requires special tools.
•
The appliance must not be positioned directly underneath a fi xed power point.
•
Do not use the appliance while it is cooling down, in order to avoid overheating with the
attendant risk of fi re.
•
Do not use the appliance in rooms less than 4m
The heater is fi tted with a safety device which will switch off the heater in case of accidental
overheating (eg. Obstruction of air intake and outlet grilles, motor turning slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of overheating
then plug the appliance in again.
6
3
2
area.
1
2
Publicidad
