Smart Start SmartMobile Basic Guía De Referencia

SETTING UP THE SMARTMOBILE BASIC UNIT:
1. Connect the power supply cord to the SmartMobile Basic™ device and plug it into an electrical
outlet. The unit display will show "Initializing," and then "Ready."
2. If the battery is completely dead, it may take a few minutes to initialize the device.
3. Place the mouthpiece in the nozzle found on top of the SmartMobile Basic device (as show below).
HOW TO TAKE A TEST:
1. We recommend drinking or swishing with water before each test to eliminate any potential
contaminants.
2. Take a deep breath and blow steadily into the mouthpiece until the device stops beeping and you hear
a click. During the test, the display will show "Testing – Keep Blowing."
3. After testing, the display will show "Analyzing – Please Wait." It will show "Ready" when the test is
complete, or show a message that indicates an incomplete test. Follow the directions on the screen.
REMINDERS
Make sure the room or testing area is well-lit.
Do not use a breath freshening agent before taking a test. Most of
these contain alcohol.
It is a violation of your program for another person to take a test on
your device.
See image to ensure the correct face-to-camera position.
DISPLAY MESSAGES:
Service Lockout in ## Hours:
into lockout. DO NOT IGNORE THE GRACE PERIOD WARNING.
Violation Lockout in ## Hours:
lockout due to violations. DO NOT IGNORE THE GRACE PERIOD WARNING.
If your device enters "Service" or "Violation" lockout, take it to your nearest service center as soon as
possible. Go to smartstartinc.com/locations to find the nearest shop.
For more information on SmartMobile Basic, visit smartstartinc.com/portable-alcohol-monitoring/smart-
mobile-basic/faq/
SmartMobile Basic Reference Guide
The number of hours remaining to have your device serviced before it goes
A reminder of the number of hours remaining before the unit goes into