BasicXL BXL-INV150U-12 Manual De Uso página 2

Useful Applications
Run notebook computers, radios, TVs, VCRs, DVD players, lamps, fax, etc.
Specifications:
Input voltage:
Input full load current:
Standby input current:
Output voltage (AC):
Output socket:
Socket type:
Output waveform:
Output Frequency:
Continuous output power:
Output power (30 min):
Peak output power:
Efficiency:
Output voltage USB:
Output current USB:
Battery low shutdown:
Thermal protection:
Cooling:
Overload protection:
High DC input voltage protection:
AC output short circuit protection:
Battery polarity protection:
Fuse:
Size (ØxH):
Weight:
Operating Instructions:
1. Always make sure to turn on the power of the inverter prior to turning on the
power of the connected equipment.
2. When using for longer periods it is wise to have the engine of the car running, to
prevent a fully discharged battery. When the alarm for low battery goes, start the
car engine to continue using the inverter and connected appliances.
3. Make sure that the maximum power demand of the connected appliances does
not exceed the output power of this inverter (150 W continuously). If the Power
indicator is flashing, it indicates that the inverter is in protection mode because of
overload. Turn off the inverter and disconnect used appliance(s).
4. If the inverter and the power indicator do not work,
but the power is on, check the fuse in the cigarette
lighter plug. If the fuse is blown, use similar fuse for
replacement.
5. If the total wattage of the connected appliance(s)
exceed(s) the output capacity of the inverter or if
ENGLISH
10-15V DC
12.5 A
<0.35 A
230 V ± 5%
1x
Schuko (-F: Pin earth)
Modified sinewave
50 Hz ± 5%
150 W
180 W
300 W
>90 %
5 V DC
500 mA
10.5 V ± 0.5 V DC
60°C ± 5°C
By fan
Yes
Yes
Yes
Yes, by fuse
20 A
165x68 mm
467gr.
1 = ON/OFF power switch
2 = USB output port
(max 500 mA)
3 = 12 V DC car connector +
fuse holder (20 A)
4 = AC outlet
5 = Power / overload indicator
2
Max. 20A