Publicidad
Idiomas disponibles
Idiomas disponibles
•
Pause for at least 5 seconds between each jet of steam.
Crease removal in vertical
•
Set the temperature regulator between the •• and Max settings and wait until the iron reaches temperature.
•
Hang the garment on a hanger and place the iron some 10-20 cm away. Never iron a garment if somebody is wearing it at the
time.
•
Press the super steam push button pausing for at least 5 seconds between each press.
Self-Cleaning
1.
Fill the water container up to the marking MAX.
2.
Insert the plug into the power socket.
3.
Set the temperature regulator to the position MAX.
4.
Let the iron warm up till the control light cuts off and lights up again.
5.
Hold the iron horizontally over a trap vessel.
6.
Set the steam regulator to Self-Clean position (
emerging from the steam escape holes at the gilding sole. Any dirt, if present, will get washed out.
7.
Release the steam regulator as soon as the water in the water container is used up.
8.
To ensure that no water remains in the steam chamber, dry the gilding sole thoroughly. For this purpose, wipe the gilding sole a
few times on a towel or an old cloth.
9.
Allow the iron to cool down before storing it away.
Instructions for use
) and hold it in this position. Now steam and boiling water will start
English
6
Publicidad
