Downloading The Settings Into Another Tv (Teach); Switching Between The Normal Tv Mode And The Hotel Mode; Resetting All The Settings To Factory Preset - Panasonic TY-FB9TU Manual De Instrucciones

Replicating the settings - CLONE BOX

Downloading the settings into another TV (TEACH)

Be sure to set the TV to the normal TV mode before downloading. If not in the normal TV mode, change the mode
referring to "Switching between the normal TV mode and the HOTEL mode" (see below).
Preparation
• Connect the receiving TV display to the AC outlet.
• Connect the Clone Box to the MATE terminal on the tuner board.
1
Turn the receiving TV display on.
2
Turn the Clone Box on.
The red and green LEDs on the Clone Box flash.
3
Press [TEACH] button on the Clone Box.
• The green LED flashes during downloading.
• The green LED lights for approx. 2 seconds when downloading is completed.
• After downloading, the receiving TV will be automatically switched into the HOTEL mode.
4
Turn the main power of the display and the Clone Box off.
Repeat the steps above to download to other TVs.

Switching between the normal TV mode and the HOTEL mode

When you used the Clone Box
Insert a slender tool about 3/4 inch (ex. a paper clip) into [AMS] hole on the Clone Box.
The green LED lights for approx. 2 seconds.
When you switch the mode with the remote control
Press [SAP], [ASPECT], and then press and hold [MUTE] for approx. 3 seconds.
Press the next button within a second.
To enter or exit the HOTEL mode menu
Press [ACTION] to enter and press again to exit.
HOTEL mode menu
SET UP menu
• SLEEP (see page 10)
• cc MODE (see page 11)
• MODE (see page 9)
• VIDEO (see page 11, MODE)
• V-CHIP SET
Does not appear in the initial setting. To display, press
[SAP], [ASPECT] and then press and hold [RECALL]
for approx. 3 seconds.

Resetting all the settings to Factory Preset

Preparation
• Connect the TV display to the AC outlet.
• Connect the Clone Box to the MATE terminal on the tuner board.
1. Turn the display on.
2. Turn the Clone Box on.
The red and green LEDs on the Clone Box flash.
3. Insert a slender tool about 3/4 inch (ex. a paper clip) into [AMS] hole on the Clone Box.
The green LED lights for approx. 2 seconds.
4. Press [SAP], [ASPECT] and press and hold [TV/VIDEO] for approx. 3 seconds.
All settings will return to the default values.
5. Turn the main power of the display and the Clone Box off.
14
LOCK menu
To display, press [ ] while highlighting "V-CHIP SET"
in SET UP menu (see left).
• CREATE CODE FIRST / ENTER CODE (see page
10)
• V-CHIP SET (see pages 10, 12)
• CODE (see page 10)
• HOW LONG? : 12HOURS (Fixed)
The settings selected in HOTEL mode returns to the
initial settings after 12 hours.