Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION!
cause false readings of the detector.
2. The movement should be slow and at a constant speed.
3. When a target under the ground surface is found and identified, the detector
will emit a single beep and the target found icon will flash. The LCD display will
also show the reading value and the depth at which the target was detected.
4. If the detector does not detect any object, make sure that the operating mode
is set correctly and that the probe is moved correctly.
5. The detector responds with a signal when it detects valuable metal objects. If
the signal does not repeat after moving the probe over the target several
times, it is probably scrap metal.
6. False signals can be caused by contaminated ground, electrical interference, or
large irregular pieces of metal. False signals are usually intermittent or not
repeated.
FACTORS AFFECTING OBJECT DETECTION:
It is difficult to obtain an accurate detection result. Factors that affect the quality of
readings are:
•
the angle of the target buried in the ground,
the depth at which the target is located,
•
the degree of oxidation of the target,
•
the size of the target,
•
•
electro-magnetic and electrical interference surrounding the target,
measurements in the area of strongly mineralized soil, fertile ground or wet
•
sand - the detector will emit sound even if there is no metal in it. In this case
The probe movement should not resemble a pendulum. This may
Publicidad
