Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Before Using Your Refrigerator
•
Remove the exterior and interior packing.
Before connecting the refrigerator to the power source, let it stand upright for approximately 4 hours.
•
This will reduce the possibility of a malfunction in the cooling system from improper handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 7)
•
Installing Your Refrigerator
This appliance is designed to be free standing only, and should not be recessed or built-in.
•
Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully
•
loaded.
Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air
•
ventilation. Adjust the feet to keep the refrigerator level.
Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
•
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Ambient temperature below 50°F or above 85°F will hinder the performance of this appliance. This
unit is not designed for use in a garage or any other outside installation.
•
Avoid locating the refrigerator in moist areas.
•
Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service
center. This unit is not designed to be installed in an RV or used with an inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 2~3
•
hours under before placing food in the refrigerat . r
Handle Install Instruction
Please note that the Handle parts are inseparable once joined. Please ensure that the handle
base is screwed firmly on the door before joining the actual handle part onto its base.
1. Take out the handle from the unit and remove the package.
2. Push the handle horizontally until it clicks in.
3. Push and pull the handle to make sure that it is installed completely.
o
4
Publicidad
