Publicidad
Idiomas disponibles
Idiomas disponibles
PORCELAIN OVEN INTERIOR (continued)
Cautions about using spray-on oven cleaners:
•
Do not allow a fi lm from the cleaner to remain on the temperature sensor - it could cause the oven to heat improperly.
(The sensor is located at the top of the oven.) Carefully wipe the bulb clean after each oven cleaning, being careful
not to move the sensor since a change in its position could affect how the oven bakes.
•
Do not spray any oven cleaner on the outside oven door, handles or any exterior surface of the oven, cabinet or
painted surfaces. The cleaner can damage these surfaces.
OVEN LIGHT REPLACEMENT (on some models)
WARNING
Before replacing the oven light bulb, disconnect the electrical power to the range at the main fuse or circuit
breaker panel. Failure to do so may result in electric shock or burn. Be sure to let the light cover and bulb cool
completely.
Wire cover holder
CARE AND MAINTENANCE
SHOCK OR BURN HAZARD
The oven light bulb is covered with a removable glass cover that is held in place
with a bail-shaped wire. Remove the oven door, if desired, to reach the cover easily.
Be sure to let the light cover and bulb cool completely.
To remove the cover:
1. Hold a hand under the cover so it doesn't fall when released. With the fi ngers of
the same hand, fi rmly push back the wire cover holder. Lift off the cover. Do not
remove any screws to remove the cover.
2. Do not touch the hot bulb with a wet cloth. Replace the bulb with a 40-watt
appliance bulb.
To replace the cover:
1. Place it into the groove of the light receptacle. Pull the wire forward to the
center of the cover, until it snaps into place. When in place, the wire holds the
cover fi rmly. Be certain that the wire is in the depression in the center of the
cover.
2. Connect the electrical power to the range.
15
Publicidad
