METAL ANTI-GREASE FILTERS
It is advised to frequently wash the metal fi lters (at least once a month) leaving them to
soak in boiling water and washing up liquid for 1 hour, taking care not to bend them.
Do not use corrosive, acid or alkaline detergents.
Rinse them well and wait for them to be completely dry before reassembling them.
They are dishwasher safe.
To extract and insert the metal anti-grease fi lters see the picture.
ZEOLITE-CARBON FILTERS
Before performing maintenance on zeolite-carbon fi lters (FCZ), remove the
lower dust fi lter (F) and vacuum any deposited dust with a vacuum cleaner.
In normal use conditions, we recommend regenerating the zeolite-carbon fi lter
every 18 months and replacing it after 3 years. Simply place it in a domestic oven at
a temperature of 200°C for approximately 2 hours to regenerate it.
Wait until the fi lter cools before reassembling it.
2
V1
1
The zeolite-carbon fi lter and lower dust fi lter cannot be washed.
IONISING TUBES (qualifi ed personnel only)
Cut-off electricity before cleaning.
In normal use conditions, we recommend cleaning every 18 months and their
replacement after 5 years.
Remove the tubes from their housing and separate the metallic lining, as descri-
bed in the instructions.
Gently clean the tube with a cloth using ethyl alcohol. Clean the metallic lining with soap
and water and thoroughly rinse it.
Make sure it is WELL DRIED (placing in a 50°C oven for 10 minutes is recommended)
before put it back on the tube.
FCZ
3
4
F
LIGHTING
The range hood is equipped with high effi ciency, low consumption LED with extremely
long duration under normal use conditions.
Should replacement be required, contact a service centre.
DISPOSAL AFTER END OF USEFUL LIFE
The crossed-out wheeled bin symbol on the appliance means that the product
is WEEE, i.e. "Waste electrical and electronic equipment'' , accordingly it must
not be disposed of with unsorted waste (i.e. with ''mixed household waste''),
but it must be disposed of separately so that it can undergo specifi c operations
for its re-use, or a specifi c treatment, to remove and safely dispose of any sub-
stances that may be harmful to the environment and remove the raw materials that can be
recycled. Proper disposal of these products contributes to saving valuable resources and
avoid potential negative eff ects on personal health and the environment, which may be
caused by inappropriate disposal of waste.
You are kindly asked to contact your local authorities for further information regarding the
designated waste collection points nearest to you. Penalties for improper disposal of such
waste can be applied in compliance with national regulations.
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented diff erently in each country, accordingly, if you wish
to dispose of this appliance we suggest contacting your local authorities or dealer to fi nd
out what the correct method of disposal is.
INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES
The crossed-out wheeled bin symbol is only valid in the European Union: if you wish to
dispose of this appliance in other countries, we suggest contacting your local authorities or
dealer to fi nd out what the correct method of disposal is.
WARNING!
The Manufacturer reserves the right to make changes to the equipment at any time and
without prior notice. Printing, translation and reproduction, even partial, of this manual are
bound by the Manufacturer's authorisation.
Technical information, graphic representations and specifi cations in this manual are for in-
formation purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any transcription
or translation errors.
21