Publicidad
Idiomas disponibles
Idiomas disponibles
If the clog does not clear, proceed as follows:
1.
Stop engine.
2.
Use your hands to remove any debris found near the top of the hopper.
3.
Use a branch (or other available device, i.e. broomstick) to dislodge debris
located toward the base of the hopper.
4.
Restart engine.
NOTE: If you're unable to pull the starter rope as a result of accumulated debris near
the impeller, follow instructions under the heading Cleaning the Reduction Chamber
in the Service section of this manual.
Chipping
Never operate the chipper shredder without chipper chute lowered into
the operating position.
Branches up to two (2) inches (model series CS2210 and CS4265) or three (3) inches
(model series CS3310 and CS4325) in diameter can be fed into the chipper chute.
Observe the following guidelines when chipping branches:
•
Keep both hands firmly on the branch as you feed it into the chipper chute.
•
Never feed more than one branch into the chipper chute at a time.
•
Never feed anything other than branches (or wood) into the chipper chute.
•
Apply intermittent pressure (force, in short pulses) while feeding larger
branches into the chipper chute, to avoid bogging or stalling the engine.
IMPORTANT! Never feed branches with a diameter greater than two (2) inches (Model
Series CS2210 and CS4265) or three (3) inches (model series CS3310 and CS4325) into
the chipper chute. Doing so can result in serious damage to your unit's chipper blades,
flails or impeller.
NOTE: For best performance, always operate the unit with sharp chipper blades. If a
noticeable loss in performance is encountered while chipping branches, the chipper
blades should be replaced.
CONTROLS & OPERATION
WARNING
Emptying the Bag
1.
Stop engine.
2.
Squeeze the locking buckle to
release the bag's drawstrap
before loosening it from the
chute deflector. See Figure 6.
3.
Empty the bag and reattach to the
chute deflector opening. Refer
to the Assembly & Installation
section of this manual.
6
Figure 6
Publicidad
