MARTINS Industries impulse MX-T1 Manual página 4

SAFETY
• Wear approved safety glasses
• Handle is not insulated, do not use near live electrical
• The tool can only be operated clockwise
• Do not use torque wrench to loosen fasteners
OPERATIONS
1-Set the desired torque value using the collar.
2-Connect the socket on the drive.
3-Place the socket on the nut and turn clockwise until the tool clicks, meaning the nut has reached the correct torque rating.
MAINTENANCE
Depending on your industry requirements, the tool should be sent to a specialised facility for calibration.
• When not in use, always set the torque value to zero to avoid stress on the mechanism.
• Keep the tool clean and in the case when not in use.
• Do not drop the tool on the ground
• Do not use the tool to loosen fasteners or with an extension bar.
BEFORE using this product, read this manual and follow all its Safety and Operating instructions.
Failure to do so may result in personal injury and/or property damage.
Retain these instructions for future reference.