Husky H4790 Manual De Instrucciones De Operación Y Lista De Partes

Operation & Parts Manual
6" Dual Action Sander
Table of Contents
•
Specifications
•
General Safety Information
•
Features & Operation
•
Maintenance
•
Parts List
•
Warranty
Specifications
Free Speed ............................................ 10,000 RPM
Pad Size .................................................................6"
Orbital Stroke ..................................................... 3/16"
Weight ....................................................... 3-1/2 lbs.
Length ........................................................... 10-1/2"
Air Inlet ................................................................ 1/4"
Average Air Consumption ............................... 4 CFM
Recommended Hose Size ................................... 3/8"
Recommended Operating Pressure .......... 60-90 PSI
General Safety Information
Read Operating Instructions
Always become familiar with all the instructions and
warnings before operating any pneumatic tool.
Always Wear Approved Eye Protection Impact
resistant eye protection should meet or exceed the
standards as set forth in the United States ANSI Z87.1,
Occupational and Educational Eye and Face Protection.
Look for the marking Z87.1 on your eye protection to
insure that it is an approved style. For further
information, ANSI Z87.1, Occupational and Educational
Eye and Face Protection, is available from the American
National Standards Institute, Inc., 11 West 42nd Street,
New York, NY 10036.
Hearing Protection is Recommended
Hearing protection should be used when the noise level
exposure equals or exceeds an 8 hour time-weighted
average sound level of 85dBA. Process noise, reflective
surfaces, other tools being operated nearby, all add to
the noise level present in your work area. If you are
unable to determine your noise level exposure, we
recommend the use of hearing protection.
Sold Exclusively at The Home Depot
2455 Paces Ferry Road, Atlanta, Georgia 30339
Description
The Husky model no. H4790 Dual Action Sander is
designed for use in industrial, woodworking and automotive
applications. Provides swirl-free surface sanding and
feather-edging. Powerful 1/2 horsepower motor for efficient
material removal. Built-in power regulator helps match
speed to job application.
Avoid Prolonged Exposure to Vibration
Pneumatic tools can vibrate during use. Prolonged
exposure to vibration or very repetitive hand and arm
movements, can cause injury. Stop using any tool if
discomfort, tingling feeling or pain occurs. You should
consult your physician before resuming use of the tool.
90 PSIG Maximum
Husky sanders are designed to operate at an air
pressure of 90 pounds per square inch gauge pressure
(90 PSIG) maximum, at the tool. Use of higher air
pressure can, and may cause injury. Also use of higher
air pressure places the internal components under loads
and stresses they were not designed for, causing
premature tool failure. The air supply should be clean
and dry, preferably lubricated. For best results drain the
moisture from your compressor daily.
Wear Respiratory Protection
It is advisable, when sanding for extended periods of
time, to wear a protective mask. This will help prevent the
inhalation of the fine dust produced while sanding.
Prolonged breathing of dust particles may lead to future
respiratory problems.
Model No. H4790
PL-0712