PRIXTON Detroit Manual De Instrucciones página 7

Fix the Legs
• Open the package, take out record player, legs and other accessories
• Put the record player base up to down
• Take our the legs from bubble bags and screw it on the metal part.
• Put the record player on the floor, then can use it.
Phono Function Operation
SET-UP: Place your record player in a secure location where it will be protected from the
elements or possible falls.
POWER CONNECTION: Connect the power by 5V DC adaptor.
LIFT THE DUST COVER: Lift the dust cover and keep it open when in use.
TURN ON: Turn on the Power Switch, note that this also controls volume. LED
ENTER INTO THE PHONO MODE: Press "M" key to select PHONO mode, the indicator
light is red.
SPEED SELECTION: Select the speed between 33, 45 and 78 rpm through speed switch
according to the speed of vinyl record.
INSERT THE VINYL RECORD (Not include): Carefully remove the vinyl record from its
case and place the record on the turntable plate.
MOVE THE NEEDLE: Take off the protector of needle, Release the tone arm lock, slowly
and gently move the needle over the record, placing it on the outermost part of the
record.
DROP THE NEEDLE: Once the needle is over the record, use the small lever on the base of
the needle and press down to lower it onto the record.
ENJOY YOUR MUSIC: Once above steps are completed, then the vinyl record will start
playing. (the turntable will stop automatically if the auto-stop switch is in the ON position
when the needle has reached the end of the vinyl record . If the switch is in the OFF
position then it will keep revolving until the tone arm is moved.)
FINISHING UP: Lift up the tone arm and put it on the rest position when finished, turn off
the Power Switch.
Connecting to an external sound system
Connect an RCA audio cable (not supplied) to the AUDIO LINE OUT sockets on the rear of
the turntable. Connect the other end of the cable to an AUDIO INPUT on the amplifier.
• Red plug into R channel output.
• White plug into L channel output.
Bluetooth function
(lift up the tone arm and put it on the rest)
• Enter into the Bluetooth mode directly when turn on this device or press "M" key to
select Bluetooth mode under the other modes, the indicator light is blue and flash.
• Make sure the available Bluetooth device into "pairing mode".
• Choose and click the right Bluetooth name to connect.
• The blue indicator light will flash slowly when Bluetooth connected.