Identification; Specifications; End Stripping Instructions; Preparation - Greenlee GTS-1930 Manual De Instrucciones

Identification

4
2
3
1. Handle
2. Bearing
3. Bushing

Specifications

Insulation Thickness Range ............... 45 mils to 110 mils
Conductor Size Range ..................... 6 AWG to 750 kcmil
Greenlee / A Textron Company
6
5
1
4. Pull Pin
5. Lock Nut
6. Depth Stop
(1.1 mm to 2.8 mm)

End Stripping Instructions

Preparation

Ensure cable has a straight, round end before
beginning.

Procedure

1. Determine the conductor type and size, and choose
the appropriate bushing; refer to Table 1. To change
bushings, pull the pull pin away from the bearing
and remove the bushing. Load the appropriate
bushing and release the pull pin.
2. Unfasten the lock nut and adjust the depth stop to
the required strip length; retighten the lock nut.
3. Insert the cable end into the bushing opening and
begin stripping by rotating the handle clockwise
while applying pressure against the cable end.
Continue stripping by ratcheting the tool down the
cable length.
4. When the desired strip length is reached, the tool
will stop its forward motion. Rotate the tool once
more clockwise to perform a square cut and remove
from the cable.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
GTS-1930