Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting and Removing Flat Panel Screen
WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
3
Tension Adjustment of Ratchet Handle: Adjust
tension in tilt brackets (BB & CC) by rotating ratchet
handle. NOTE: If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up or
down position or interference will occur while hooking tilt
brackets to wall plate (AA). Slowly hook tilt brackets
(BB & CC) onto wall plate (AA) and swing screen down
as shown in fig. 3.1. Tilt bracket hooks must fully
engage wall plate as shown in detail 1. Using phillips
screw driver or security allen wrench (FF), turn safety/
security screws on tilt brackets (BB & CC) clockwise till
screw tip securely contacts wall plate as shown in
cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety/security screws on tilt
brackets (BB & CC) three full turns. Adjust screen as
shown in figure 3.2. Tighten safety/security screws on
tilt brackets till screw tip securely contacts wall plate
as shown in cross section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
Adjusting the Tilt Angle of the Flat
Panel Screen
4
For preset tilt angles use Increlok™ and for custom tilt
angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to find tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to step
3 for tension adjustment of handle). Push or pull from
top or bottom of screen to adjust tilt as shown in figure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
AA
DETAIL 1
AA
SAFETY/
SECURITY
SCREW
CROSS SECTION
IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
9 of 27
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB
&
CC
RATCHET
HANDLE
BB
&
CC
fig 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fig 4.1
ISSUED: 11-26-07 SHEET #: 202-9256-1
© 2007, Peerless Industries, Inc. All rights reserved.
fig 3.1
Publicidad
