Publicidad
Idiomas disponibles
Idiomas disponibles
4 Operating
GB
4.4
Starting
application
42
Make sure that the skin areas to be treated are shaved, dry, clean and
free of creams, deodorants etc. Proceed as follows:
1.
Carry out steps 1 and 2 from chapter 4.2 "Skin test".
2.
Set the intensity that you have tested and which is suitable for your
skin, by pressing the ON/OFF button
long, until the desired intensity (Level 1 to 5) is lit on the intensity dis-
2
play
.
3.
Place the light area
trigger a light pulse. The skin contact area
(the readiness indicator
can be emitted by the device. When the pulse is emitted, you will see
a bright flash and may hear a clicking sound.
4.
Now place the device on another area of the skin while it charges for
the next light pulse.
5.
Then emit a new light pulse on the other skin area.
6.
Repeat this procedure for other planned skin areas.
Switch the device off by pressing and holding the ON/OFF button
7.
WARNING
•
Never emit several light pulses in succession onto the same
area of skin!
•
If pain, swelling or other unusual reactions occur during the
application, immediately stop the test and do not carry on
using the device. Contact your doctor.
6
onto the skin and press the trigger button
starts to flash green), so that a light pulse
3
briefly in succession so
1
7
must lie fully on the skin
8
to
1
.
Publicidad
