Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Saw blade
2
Guide
3
Fixing screw
4
Safety tab
PREPARING
1. Insert the saw blade (1) into the device as shown above. Fasten the saw blade (1) with the fixing
screw (3) using the Allen key (8).
2. Remove the sealing cap from the air inlet (6) and install the quick coupling nipple into the air inlet.
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger (5) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Check the function of the device by folding the safety tab (4) and then pressing the trigger (5).
7. The device is now ready to use.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information. Dispose
of this product at the end of its working life environmentally.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches
tool's air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
5
Trigger
6
Air inlet
7
Air quick coupling nipple
8
Allen key for fixing screw
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
