Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Install the bagger cover onto the hanger
assembly, as seen in Figure 11. The cover
goes inside the two mounting tabs.
6.
Slide the hinge pin (711-04988) into
the hole located on the mounting tab,
as shown in Figure 12. Use the cut-out
window (see inset in Figure 12) to line
up the hinge pin on the other side and
push pin all the way in until it reaches the
end-stop. At this point the pin clips into
place and is secured by a tab in the bagger
cover. See Figure 13.
7.
Open bagger cover by pushing in on the
rear, right-side tab with your right hand (1),
and lifting the cover with your left hand in
the center rear of
the bagger cover (2) as shown in Figure 14.
8.
Install both grass bag assemblies (664-
05104) onto the hanger assembly rails by
inserting the front edge in first (1), and
then setting the back edge down until
it fits into the assembly (2), as shown in
Figure 15.
Figure 12
Figure 14
ASSEMBLY AND INSTALLATION
2
Make sure screen sits
under the cover's lip
Figure 10
Figure 11
Figure 13
1
2
Figure 15
Installing the Boot
1.
Install the boot rod mount
(747-06043) to the boot using two
shoulder screws (738-1225) and
two flange lock nuts (712-04064)
from hardware pack 689-00636.
Ensure that the shoulder screws are
installed on the interior of the boot.
See Figure 16.
2.
With the tractor's discharge chute raised up
and held open (1), install the boot by placing
the boot mounting rod into the hole provided
in either your deck wheel bracket or boot
mounting tab (2), as shown in Figure 17.
3.
Secure the boot to the deck using a wing knob
(720-04122) from hardware pack 689-02364.
See Figure 18.
NOTE: If present, remove the protective cap off of
the mounting stud on the mowing deck as shown in the upper inset of Figure 18.
IMPORTANT! Be certain that the bottom of the discharge chute is located inside of the lip of
the deck opening, as shown in Figure 19.
2
1
Figure 18
Installing the Hose
1.
Thread the upper end of the hose securely into
the upper chute support. There are two tabs
on the lower inside part of the upper chute
support to allow for secure threading. See
Figure 20.
NOTE: The hose and upper chute support are
left-hand threaded. Thread counter-clockwise
until secure.
2.
Slide the hose over the boot mounted on the
cutting deck, as shown in Figure 21.
3.
Make sure the connection is secure
and there are no gaps between the
hose and the boot.
4.
If open, close the grass catcher
cover prior to mowing.
7
Figure 16
1
2
Figure 17
Figure 19
Figure 20
2
1
Figure 21
Publicidad
