Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking
Carton Contents
• Electric blower + vacuum + mulcher
• Blower tube
• Blower concentrator nozzle
• Front vacuum + mulcher tube
• Rear vacuum + mulcher tube
• Collection bag
• Manual with registration card
1. Carefully remove the electric blower + vacuum + mulcher
and check to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store.
Please call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the electric blower +
vacuum + mulcher. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils
or small parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
m
WARNING!
Before performing any maintenance,
make sure the tool is unplugged from the power supply.
Failure to heed this warning could result in serious personal
injury.
m
WARNING!
To prevent serious personal injury,
make sure the switch is in the OFF (O) position, the unit is
unplugged and the impeller has come to a complete stop
before attaching or removing tubes.
Assemble as a Blower
1. Slide the blower tube forward until the notched area on
the blower housing clicks into the slot on the blower tube
(Fig. 1).
+ Sun Joe
customer service
®
®
2. Insert the concentrator nozzle onto the end of the blower
tube until it locks into position (Fig. 1).
NOTE: The concentrator nozzle is used to increase
air flow in tight areas (i.e around flower beds,
under decks, etc.).
Fig. 1
Air outlet
3. Before using the blower function, securely fasten the inlet
cover over the air inlet by closing the inlet cover until the
lock button snaps into the locked position (Fig. 2).
Fig. 2
Inlet
cover
4. To remove the blower tube, turn the ON/OFF power switch
to the OFF (O) position and disconnect the tool from the
power supply.
5. Press the tube release button and remove the blower tube
(Fig. 3).
Fig. 3
ON/OFF switch
Tube release button
7
Notched
area
Slot
Blower tube
Concentrator
nozzle
Inlet cover
lock button
Blower tube
Publicidad
