Remove Unit - Clatronic ar 815 USB/CR Instrucciones De Servicio

Remove Unit

Follow these instructions to remove the unit:
‹
Remove the frame.
‹
Insert left and right installation keys in the slots left and right
(the claws are now bent back).
‹
Slide the unit out of the sleeve.
NOTE
►
Unevenness of the casing can cause the claws to lock.
Unlock the claws with the installation keys, if necessary.
Toyota or Nissan Installation
NOTE
►
Sleeve, frame and mounting strip are not needed.
Use the threads on the side of the casing (A) to mount the unit on
the vehicle bracket (supplied with your car). The holes are marked
with T (for Toyota) and N (for Nissan).
D
B
‹
Loosen the mounting screws for the hooks left and right at the
front of the unit and remove the hooks.
‹
Mount the brackets (B) with screws on the unit (D).
66
A
B
C
Connect External Audio Device
‹
Connect line out of the external audio device to
jack on the front panel.
‹
Select playback mode for external device by repeatedly press-
ing MODE (21) until AUX is displayed.
Start-up
To protect against theft remove the front panel. Do not keep the front
panel in the car.
NOTE
►
Keep the front panel in its casing.
►
Do not touch the contacts on the unit or on the front panel.
Attach Front Panel
‹
Place the front panel with its right side in the frame.
‹
Now press the left side until it locks in place.
‹
Ensure the front panel is attached properly. If the front panel is
not attached properly this can cause malfunctions.
Detach Front Panel
‹
Press unlock button (A) for the front panel and remove the
front panel (B).
A
AUX IN (11)
B