GRE VCB10P Manual De Instrucciones página 5

2. Installation
2.1 Filter element assembly and body parts assembly
Assemble the body parts in the direction of the arrow.
1. 1.
2.2 Assembly of suction
head
Insert the entire suction head di-
rectly into the Cover the garbage.
3. Power on and Turbo speed mode
3.1 Press and hold the power switch button of
the cleaner for 2-3 seconds. If the «green» indi-
cator light is always on, it means the machine
is started. Please put the product into the wa-
ter for operation, so as to prevent the seal failure
of the oil seal when the product is idling. At this
time, the cleaner is in low speed mode.
3.2 Press and hold the power switch button of
the cleaner for 2-3 seconds again, you will find
that a "blue" indicator light is on, and the cleaner
enters the "high speed mode". At this time, the
cleaner can clean up a large number of large
particles of sediment at the bottom of the pool.
Long press the switch button for 2-3 seconds
to switch between "low speed mode" and "high
speed mode".
3.3 Turn off : When you lightly press the switch
button, all the indicator lights are off and the
cleaner is turned off.
2. 2.
2.3 Handle assembly
(1) Handle assembly.
This handle is used to
clean walls, steps, seats
and corners, as shown in
figure "A»
Note: the product can be connected with handle A or
standard telescopic rod B.
3. 3.
(2) Assembly of telescopic
rod (included)
Cleaner can be connected
to a standard telescopic
rod, as shown in figure "B».
A
Indicator light
ON/Low
Long press
speed
OFF
4. 4.
B
ON/OFF
High
speed