Autoadapt Turny Evo Manual De Instalación página 37

Edit movement path, comfort
The front end position allows you to edit and save separately, steps 9-11. To edit
and save the rear end position, steps 12-13, editing of the front end position is
required first.
9
10
11
12
13
Edit movement path, swivel out
14
15
Run the seat in normal operating mode and swivel the seat fully into the car.
Activate the programming menu. Hold down the yellow button in the middle of
the hand held control until the "enter code" screen is displayed. Then enter the
code 1, 2, 3, 4
(Screen 10 comes up)
Use 2 and 4, "forwards" and "backwards", to run to the desired front end position.
(When screen 11 comes up it is possible to save the new end position)
Alternative A - Press 1 to "save" and exit from the programming mode.
Turny Evo is now back in its normal operating mode.
Alternative A - Press 3 to "save and continue" and program rear end position.
(Screen 12 comes up)
Use 2 and 4, "forwards" and "backwards", to run to the desired rear end position.
(When screen 13 comes up it is possible to save the new end position)
The rear end position must be programmed behind the starting position for "swiv-
el out". If the end position is programmed in front of the starting point, it will not
be possible to manoeuvre the seat and the programming must be done again.
Rear end position "comfort"
Press 1 to "save" and exit from the programming mode.
Turny Evo is now back in its normal operating mode.
It is possible to begin editing from any point on the path. If the first part of the
programming is good you do not need to program the whole path. Swivel out in
normal operating mode to the point from which new programming is preferred
to be done. Activate the programming menu. Hold down the yellow button in the
middle of the hand held control until the "enter code" screen is displayed. Then
enter the code 1, 2, 3, 4
Press 2 for "continue". Programme new swivel and lift, see illustration 6-8.
Press 1 to undo and cancel.
Press 4 to go straight into the emergency operation menu
Getting seated Turny Evo
Movement path "swivel out"
Starting point "swivel out"
This starting position was previously
marked with a piece of tape in the
programming.
37
EN