Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
BEFORE CALLING FOR SERVICE
If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem
persists, see Troubleshooting below. The problem may be something very simple that can be solved without a service
call.
TROUBLESHOOTING
Fault
Compressor is Not Running
Cabinet Temperature is too
Warm
Interior Light is Not Working
Condensation is Collecting
on the Cabinet and/or Floor
All manuals and user guides at all-guides.com
Probable Cause
Fuse blown or circuit breaker
tripped
Power cord unplugged
Thermostat set too high
Thermostat is set too high
Airflow is blocked
Low refrigerant levels
Door is slightly ajar
Poor switch connection
Bulb is not connected
Bulb has burned out
Gasket is not sealing properly
Page 17 of 58
Action
Replace fuse or reset circuit
breaker. If replacement of fuse or
reset of circuit breaker doesn't
correct the problem contact a
qualified service technician.
Plug in power cord
Set thermostat to lower
temperature
Set thermostat to lower
temperature.
Re-arrange products to allow for
proper air flow. Make sure there
is at least four inches of
clearance from the fan
Contact a qualified service
technician to check refrigerant
levels
Make sure door is completely
closed.
Turn off light switch and turn it
back on.
Make sure the bulb is correctly
inserted in the socket.
Replace the bulb. If replacement
of bulb doesn't correct the
problem contact a qualified
service technician.
Clean, repair, or replace the
gasket as necessary
Publicidad
