Bosch GWS Professional 2200-180 H Manual Original página 18

18 | English
Secure the workpiece. A workpiece clamped with
u
clamping devices or in a vice is held more secure than by
hand.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for cutting, roughing and brush-
ing metal and stone materials without the use of water.
A special protective guard for cutting must be used when
cutting bonded abrasives.
Sufficient dust extraction must be provided when cutting
stone.
With approved abrasive tools, the power tool can be used for
sanding with sanding discs.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Spindle lock button
Technical data
Angle grinder
Article number
Rated power input
Power output
Rated speed
Max. grinding disc diameter
Grinding spindle thread
Max. thread length of grinding spindle
Weight according to EPTA-Procedure 01:2014
– with additional low-vibration auxiliary handle
– with standard auxiliary handle
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
When switching on power tools with starting current limitation, the voltage drops briefly. Interference with other equipment may occur in the
event of unfavourable conditions in the electricity supply. Malfunctions are not expected if the impedances in the electricity supply are below
0.25 ohms.
Noise/Vibration Information
Noise emission values determined according to
EN 60745-2-3.
1 609 92A 435 | (27.11.2018)
(2) On/off switch
(3) Side handle (insulated gripping surface)
(4) Grinding spindle
(5) Protective guard for grinding
(6) Locking screw for protective guard
(7) Hub flange with O‑ring
A)
(8) Grinding disc
(9) Clamping nut
(10) Two-pin spanner for clamping nut
(11) Quick-clamping nut
A)
(12) Carbide grinding head
(13) Protective guard for cutting
A)
(14) Cutting disc
A)
(15) Hand guard
A)
(16) Spacer discs
A)
(17) Rubber sanding pad
A)
(18) Abrasive disc
A)
(19) Round nut
A)
(20) Cup brush
(21) Extraction guard for cutting with a guide block
A)
(22) Diamond cutting disc
(23) Handle (insulated gripping surface)
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GWS 2200-180 H
3 601 H51 X..
W 2200
W 1380
-1
min 8500
mm 180
M 14
mm 25
kg 5.1
kg 5.0
/ II
Typically the A-weighted noise level of the power tool is:
Sound pressure level 92 dB(A); sound power level 103
dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Total vibration values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-3:
A)
A)
A)
A)
GWS 2200-230 H
3 601 H52 X..
2200
1380
6600
230
M 14
25
5.1
5.0
/ II
Bosch Power Tools