Zbeamz Corvus Manual Del Usuario página 30

Press off existing modes. Press
Automatic mode will enable you to run the automatic programs on the product.
To turn on/off Automatic mode:
Press , or
Sound-Active mode will enable the product to respond to the music.
To turn on/off Sound-Active mode:
Press
To adjust select an the automatic program..
1. Press on the remote controller.
2. Press or
3. Press again to turn off
Press to make a circle, press again to select a moving circle.
Press to make a straight line, press again to select a moving straight line
Press to make a square , press again to select a moving square.
To adjust sound sensitivity for in Sound-Active mode
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity.
To enable DMX or disallow DMX on the product.
Press on the remote controller, the product work on the DMX controlling modes.
Press , ,
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
return the last modes.
on the remote controller.
or on the remote controller.
to change the program.
, , , or to choose your colour.