Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIAL INSTRUCTIONS
This appliance has a polarized plug, To reduce the risk of electric shock, this plug is intended
to fit into a polarized outlet only one way, If the plug does not fit fully into the outlet, reverse
the plug, If it still does not fit, contact a qualified electrician, Do not attempt to modify
the plug in any way.
Notes on the cord
a) A short power-supply cord (or detached power-supply cord) is to be provided to reduce risks
resulting from becoming entangled in or tripping over a long cord.
b) Longer detachable power-supply cords or extension cords are available and may be used
if care is exercised in their use.
c) If a long detachable power-supply cords or extension cord is used,
1) The marked electrical rating of the detachable power-supply cord or extension cord should
be at least as great as the electrical rating of the appliance.
2) If the appliance if of the grounded type, the extension cord should be a grounding-type 3-wire cord,
3) The longer cord should be arranged so that it will not drape over the counter top or table top
where it can be pulled on by children or tripped over.
KNOW YOUR COFFEE MAKER
Reusable mesh filter
Filter basket
Brewing chamber
Carafe
BEFORE FIRST USE
BEFORE FIRST USE
Check that all accessories are complete and the unit is not damaged. Add water into water tank to
he max level and brew water for several times without coffee powder, then discard the water.
Clean all detachable parts thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Lift the water reservoir lid and fill the water reservoir with 600ml of water (about one full glass)
2. Put 4-5 tablespoons of finely ground coffee into the reusable mesh filter for a full glass of coffee
Note: regular coffee grounds require more coffee per cup to achieve the strength of finer
coffee grounds
3. Gently shake the mesh filter to distribute the coffee evenly.
4. Place the mesh filter into the filter basket and place filter basket into the brewing chamber
(see the figure)
5. Close the top lid.
6. Place the glass into the base.
7. Plug the power cord into a standard 120volt AC electrical outlet.
8. Press the switch; the switch indicator light will illuminate , verifying that the coffeemaker
is operating. Caution: Don't open the filter bracket during the brew cycle, as scalding may occur.
9. Allow all the coffee to drip from the filter bracket into the glass before removing the glass .
Note: since coffee grounds absorb some water during brewing , the amount of brewed coffee
will be slightly less than the amount of water pure dint other reservoir.
10. If brewing another glass of coffee at this time proceed to the brewing a second glass
Water reservoir lid
of coffee section, when all brewing is complete, unplug the power cord from the electrical outlet.
Brewing a Second Glass of Coffee:
To brew another Glass of coffee, allow the Coffeemaker to completely cool (about three minutes)
after the Switch has shut off. Rinse the Glass and the Reusable Mesh Filter with water.
Repeat the brewing procedure.
CLEANING AND MAINTENANCE
Water reservoir
CAUTION: Be sure to unplug this appliance and allow the product to cool completely before
cleaning. To protect against electrical shock, do not immerse cord, plug or unit in water or liquid.
After each use, always make sure plug is first removed from wall outlet.
1) The Filter Basket may be placed on the upper rack of a dishwasher for cleaning or hand washed
in warm, soapy water. The Reusable Mesh Filter must be washed by hand.
Switch
NOTE: When washed in a dishwasher, the parts may appear to fade. Restore by polishing them with
a soft, dry cloth.
Bottom cover
2) Wipe the exterior surface of the Coffeemaker with a soft, damp cloth. Do not use metal scouring
pads or abrasive cleaners.
Publicidad
