Power Adhesives tec 806-12 Instrucciones De Uso página 2

SAFETY INSTRUCTIONS
EN
Do not touch the nozzle or molten adhesive
with bare skin as they are hot - the operating
temperature of this tool is approximately
200°C / 392°F (LT 120°C / 248°F). Protective
gloves should always be worn. Careless
handling can cause skin burns. If molten
adhesive comes into contact with the skin,
immerse the affected area immediately in
plenty of cold water. Seek medical advice if
necessary. In addition to the safety instructions
herein, any statutory regulations, local fire
insurance regulations, or other generally valid
"regulations for accident prevention" must be
complied with when using this tool.
Repairs should only be undertaken by
competent personnel with the adequate
electrical knowledge. Before proceeding
with any maintenance or repair operation,
disconnect the tool from the mains electricity
supply. If in doubt, contact your supplier.
• WARNING - This tool must be placed on its
stand when not in use; do not leave the tool
unattended when switched ON.
• Place the tool on its stand after use and
allow it to cool down before storage.
• Never use the tool if it is damaged in any
way. If the supply cord is damaged, it must
be replaced by the manufacturer, its service
agent or similar qualified persons in order to
avoid a hazard.
• Do not use this tool whilst under the influence
of drugs or alcohol.
• Do not use this tool in damp rooms, and do
not expose to rain, moisture or immerse in
water.
• Do not use this tool in the vicinity of any
heat-sensitive materials, or any flammable
materials, liquids, or gases, and do not apply
to the same place for a long time.
• Only use extension cables with a wire cross-
section of 1.5mm² / 16 a.w.g. and no more
than 20m / 65 ft in length.
• Depending on the country, this tool may
be fitted with a polarized plug, intended to
be fitted into a polarized socket. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit please contact the
manufacturer. Do not modify the tool's plug.
Never pull on the tool's connecting cable.
• This tool can be used by children 8 years
and above as well as persons with reduced
physical, sensory or mental capabilities, or
lack of experience or knowledge, only if they
have been given supervision or instruction
concerning the safe use of the appliance and
understand the resulting dangers.
• Children are not allowed to play with the
appliance. Cleaning and user maintenance
must not be performed by children without
supervision.
AVOIDING PROBLEMS
• Ensure that tool has reached temperature before
operating.
• Do not leave tool switched on for long periods without
useIf tool is not to be used for more than 40 minutes,
switch off and restart when required.
• Never lay the tool on its side. Always use stand provided,
the optional bench stand or the suspension unit.
• Only use adhesives designed for use with this tool.
• Never remove a partially used glue stick. This can lead
to irreparable damage.
• Hotmelt glue can be used instead of nails, staples,
tapes, and liquid glues. However they should not be used
in place of structural connections when heavy loads are
involved.
• Do not use hotmelt glue for objects that are exposed to
extreme heat. Some glues that can be used in this tool
will soften at 60°C (140°F).
Do not connect to the main supply at this point!
1. Attach the tool stand
2. Load the tool by inserting an adhesive stick into the
rear
2
3. Operate the trigger to feed the stick forward until
resistance is felt
3
4. Connect to main supply and switch on tool
1
4