9.3 Reset to default values
1. Switch the appliance on by pushing the ON/OFF button
(A9);
2. Extract the ground coffee container (A12) or the filter
holder accessory (A7) (if inserted);
3. Press both buttons simultaneously: the appliance reset to
the default values of display contrast and grinding time
when using the filter holder accessory;
4. Insert the ground coffee container or the filter holder ac-
cessory: the appliance is ready to use.
10. CLEANING
Danger!
Before performing any cleaning operations, the machine must
be turned off and disconnected from the mains power supply.
Never immerse the coffee machine in water.
1. Unplug from the mains.
2. Unhook the coffee beans container (A1) rotating it coun-
terclockwise and extract it. Ensure it is empty when
removing;
3. Extract the ground coffee container (A12);
4. Extract the filter holder accessory's box (A6);
5. Lift the ground coffee container's tray (A8);
6. Wash all the accessories with soapy mild water: do not
wash in dishwasher! Dry thoroughly the accessories be-
fore use.
13. TROUBLESHOOTING
The appliance does not work.
The appliance stops during grinding.
There is not enough ground coffee.
Regularly clean the grinders, proceeding as follows:
1. Turn counterclockwise the regulator, to "OPEN" position
2. Extract by lifting the upper grinder (fig. 13);
3. Clean the extracted grinder with the stiff bristle brush
4. Clean the inner grinder with a brush and vacuum up the
6. Re-insert the upper grinder and turn the regulator by
11. TECHNICAL DATA
Voltage: ..................................220-240V ˜50/60 Hz max. 10A
Absorbed power: .......................................................... 150W
Weight: ..........................................................................3.5kg
12. DISPOSING OF THE APPLIANCE
Make sure the plug is correctly plugged into the mains socket and is functioning
correctly.
Neither the ground coffee container (A12) nor the filter-holder accessory (A7) is in-
serted. Insert the required accessory
The accessory is not inserted correctly. Extract, then insert again.
The beans container is not inserted (A1). Insert the container.
The beans container (A1) is not inserted correctly. Extract, then insert again.
The appliance has overheated.
The thermal cutout on the motor has tripped.
Contact an authorised Customer Services.
Over time the burrs wear down. Replace them with new burrs purchased from an
authorised Customer Services centre (see section "10. cleaning")
14
Please note:
(fig. 12);
(fig. 14);
residues of coffee with a vacuum cleaner (fig. 15);
choosing the desired grinding level.
This appliance complies with European regulation no.
1935/2004 on food contact materials.
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste sepa-
ration and recycling centre.