Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the sprayer support
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Insert the sprayer ange (E) through the far
right hole on the sink.
□
Screw the sprayer mounting nut (F) onto the
sprayer ange (E) shank from underneath the
sink, and hand tighten. Do not overtighten.
E
F
2
Installing the faucet assembly
NOTE: If the sink is uneven, use silicone under the
gasket (B).
□
Ensure the gasket (B) is on the bottom of the
new faucet (A). Place the faucet (A) through
the mounting holes in the sink.
□
Insert the side sprayer (D) hose down through
the sprayer ange (E) and sink. Align the
tabs (1 & 2) on the quick connects (3). Push the
quick connector housing rmly upward and
snap it onto the receiving tube tab. Pull down
the hose moderately to ensure the connection
has been made.
1
3
2
4
A
B
D
E
Publicidad
