Rampage Products 68111 Instrucciones De Instalación página 7

Fabric Installation
5
Start zipper on the side window about 6 inches.
Insert the plastic strip on the front of the side window into channel on the front support
bow/door surround.
Insert the plastic strip on the bottom of the side window into the side Belt Rail .
NOTE: Start at front end of the strip and work along it to the other end. Close the
horizontal and vertical zippers on the side indow. Repeat this step for opposite side.
See Figure 7
Figure 7
6
Install rear window to main skin by bringing
both zipper pulls to end of zipper on driver
side and sliding the tab on the window side
through both. Pull the upper zipper pull up
and over to the opposite side.
Slide the Tailgate Bar onto the flap bottom
of the rear window. Center the Tailgate Bar
to the vehicle.
See Figure 8
7
Rotate the Tailgate Bar downward and
toward the vehicle. Push the Tailgate Bar
into the receiving channel in the brackets
mounted on either side of the Jeep's rear
door. Make sure that the Tailgate Bar is
secure.
See Figure 9
Figure 8
Figure 9
Page 7 of 9
Front Support Bow/
Door Surround
Side Belt Rail