Fulgor Milano F4GK42 1 Serie Instrucciones De Installación página 17

General Information
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse having amperage as noted on the rating plate. We
recommend you have the electrical wiring and hookup of
your cooktop connected by a qualified electrician.
After installation, have the electrician show you where your
main cooktop disconnect is located. Check with your local
utilities for electrical codes which apply in your area. Failure
to wire your cooktop according to governing codes could
result in a hazardous condition.
If there are no codes, your cooktop must be wired and fused
to meet the requirements of the National Electrical Code,
ANSI/NFPA No. 70 - Latest edition.
You can get a copy by writing:
National Fire Protection Association
Battery march Park
Quincy. MA 02269
In Canada your cooktop must be wired and fused to meet
the requirements of the Canadian Electrical Code.
Be sure the installation of this product in a mobile home
conforms with the Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must follow the standard
for Manufactured Home Installations, ANSI A225.1 and
Manufactured Home Installations, Sites and Communities
and ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard by Writing:
Office of Mobile Home Standards HUD Building
451 7th Street, S.W.
Washington, D.C. 24010
LOCATION OF RATING PLATE
5 - Electrical Requirements
Electrical Connection
An adequate electrical supply and outlet must be used to
operate the electrical parts of your cooktop.
CAUTION
Electrical Grounding Instruction
Plug into a grounded 3 prong outlet. Do not remove ground
prong. Do not use an adapter. Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
IMPORTANT
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which must be used with a properly
grounded 3-hole outlet with a standard 120 Volt, 60 cycle
AC household current. If you do not have a 3-hole grounded
outlet, have a qualified electrician change your old one.
A grounding adaptor will be needed to convert the old
one until the outlet can be replaced. This method is only
temporary, and a qualified electrician should test it to be
sure it meets requirements.
Electrical Requirements
Do not under any circumstances cut or remove grounding
prong from the cooktop cord.
GROUNDING PRONG
EN
13