Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING MANUAL
SPRAY GUN for sprayable joint sealant in cartridges
with round threads
Use as intended
The gun is designed to use 310 ml plastic or aluminium
cartridges with round threads. Application of sprayable
joint sealant to various structures is possible.
For your safety
Hazard-free work with the device is only possible if you
read the operating instructions and safety instructions
through in full and strictly follow the instructions contained
therein.
Arrange to have practical instruction before your
first use.
Check the device before each use.
Allow only a specialist to make repairs.
Alteration or modification of the device is
forbidden.
Use only original accessories.
Use the device only with the prescribed
pressure.
Do not spray into flames or onto glowing bodies.
Working areas must be brightly lit, well
ventilated and must conform to applicable health
and work safety regulations.
Do not inhale spray mist.
Store the device and its accessories out of reach
of children.
Device Characteristics
Max. Press.
8 bar
Work. press.
2-6 bar
Capacity:
310 ml cartridge
When using a air-pressure reducing valve the working
pressure is set to 4 bar.
Safety Instructions
Check the gun for correct operation before use. Product
nozzle (32) and nozzle cap (33) must allow free flow.
Check the gun for visible damage. When dealing with
chemical materials, observe the appropriate guidelines
and safety rules.
Start up
Check line pressure in the compressed-air distribution
system and adjust if necessary. For optimal operation of
the compressed-air tool, clean, dry air is absolutely
necessary. This can be provided by a water and oil
separator integrated into the compressed-air system,
which also considerably improves the spray behaviour.
Working Instructions / Application
Unscrew the pipe sleeve (28). Puncture or cut the
cartridge at the thread. Remove the cover at the base of
the cartridge. Screw the cartridge finger-tight into the
cartridge holder (25). Turn the pipe sleeve (28) over the
cartridge in the cap (22). Close the regulating screw (29).
Connect the gun to the compressed-air supply.
When the trigger is depressed, material issues from the
product nozzle (32). By opening the regulating screw
(29), air is added to the material flow; application of the
material to various structures is possible.
Regulating screw closed:
Air spray shut off = bead application
Regulating screw open:
Air spray on = spray application
The material flow can be adjusted using the stop screw
(10). The spray pattern can also be altered by unscrewing
the nozzle cap (33). These adjustments can be set to
achieve an optimal spray pattern with each material.
When finished working
Disconnect
the
distribution system.
ATTENTION:
There must always be a cartridge in the gun; otherwise
the material hardens in the gun due to entering air and
humidity.
Store the device and its accessories out of reach of
children.
Cleaning
Clean the spray gun after each use. Dried material can
be removed with a piece of wood, plastic spatula, etc.
Faults
Valve bolt (11) is stuck or does not close:
Put oil on the valve bolt or into the air intake port
of the gun. Depress the trigger several times.
Gun does not spray properly:
Remove adhering hardened material from the
nozzle cap (33) and product nozzle (32). Check
whether the O-ring (26) is damaged – this can
allow air to enter the cartridge – spray pattern is
affected.
Environmental Protection
The device, its accessories and packing material should
be recycled in an environmentally correct manner.
Guarantee
We guarantee this device in accordance with legal and
country-specific requirements (certified by invoice or
delivery note). Damage attributable to normal wear,
overloading or inappropriate treatment are excluded from
the guarantee. Damage caused by manufacturing or
material defect will be corrected without charge by
replacement or repair. Claims can only be acknowledged
if the device is sent fully assembled to the supplier.
- 3 -
device
from
the
compressed-air
│ENG│
Publicidad
