Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Place the fountain (A) on a level surface, away
from areas where it is likely to get clogged with
leaves and make sure that the cable will reach
the socket. Open the back cap (C) located at
the back of the fountain (A). Pull out the clear
flexible hose from the fountain door located
inside of the fountain (A), and connect it to the
pump (B) outlet, as shown.
2. Place the pump (B) inside of the fountain (A).
Pull out the pump (B) power cord and close the
back cap (C).
3. Fill the fountain reservoir with clean water until
the pump (B) is completely submerged. Make
sure the water does not exceed the max line on
the fountain base. Plug the pump's cord into a
GFCI outlet. Water will begin to flow after a few
moments.
CAUTION: Always ensure the pump is completely
submerged in water. If the pump is not completely
submerged at all times during operation, the pump
will not work properly and damage will occur.
1
2
3
6
ON
OFF
Publicidad
