ELICA KIT0121468 Manual Del Usuario página 3

CONFORMITY
Elica remote control complies with the
following requirements:
-FCC (Federal Communications
Commission) Part 15.
Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
Changes or modification not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
NOTE 1: This equipment has been tested
and fiund to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rule. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance.
However, there is no guarantee that
interference to radio or television reception,
which can be determined by turning the
equipment o and on, the user is encoura-
ged to try correct the interference by one
or more of the following measure:
-reorient or relocate the receiving antenna.
-increase the separation between the
equipment and receiver.
-connect the equipment into an outlet on a
circuit di erent from that to which the
receiver is connected.
-consult the dealer or an experienced
radio/TV technician for help.
DISPOSAL WARNING
Do not dispose of electrical products in the
general waste and ensure the used product
or batteries are disposed safely according
to your local authority and regulations.