Descargar Imprimir esta página

Greencut GS650X Manual De Instrucciones página 76

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

76
LOW POWER
PROBLEM
Does the engine
overheat?
The engine knocks
or makes noises
The engine does not
run normally at all
speeds.
Black smoke or
uncarbonated fuel
escapes from the
exhaust pipe.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
TRANSPORTATION AND STORAGE
Allow the equipment to cool completely before transporting or storing.
Avoid a location exposed to sunlight when placing the machine in a vehicle. If the machine is left in a locked
vehicle for many hours, high temperatures inside the vehicle can cause the fuel to evaporate and cause a possible
explosion.
To prevent fuel loss during transport, the product should be secured in its normal operating position and with
the fuel cap closed.
Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
The equipment is not weatherproof and should not be stored in direct sunlight, high temperatures or in damp
places.
Never store the equipment in places where flammable materials, combustible gases or liquids, etc. are present.
Always store the machine with the cutting element protection installed.
POSSIBLE CAUSE
The operator is overoperating with the
machine.
The carburetor mixture is too lean.
The fan, fan cover, or cylinder is dirty or
damaged.
He's overheated.
Incorrect fuel.
Carbon deposits in the combustion
chamber.
There are carbon deposits on the piston
or muffler.
The air filter element is clogged.
Spark plug is loose or damaged.
Air escapes or the fuel line is stuck.
There's water in the fuel.
The piston is sticking.
Defective carburetor and/or diaphragm.
The fuel mixture for a two-stroke engine
is incorrect.
SOLUTION
Cut at a slower speed.
Take the machine to an Official Technical
Service.
Clean or replace as necessary.
Check that the fuel is the correct octane
rating, check that there is no alcohol in
the fuel.
Fill the machine with the correct fuel.
Take the machine to an Official Technical
Service.
Clean or replace the air filter.
Tighten or replace the spark plug and
restart the machine.
Repair or replace the fuel filter and/or
fuel line.
Fill the tank with the correct fuel/oil
mixture.
Take the machine to an authorized
Service Facility.

Publicidad

loading

Este manual también es adecuado para:

Gs620x