Installing The Filter - Impecca IPAC16-BRB Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING THE REMOTE CONTROLLER BATTERIES
1. Press gently on the tab located on the back side of the remote control unit. Lift out
the battery compartment cover.
2. Replace the batteries with two AAA 1.5v batteries. Insert batteries while respecting
the polarity of the batteries (+ and - sides). Replace both batteries at the same
time; never insert an old battery with a fresh battery to avoid a battery leak.
3. Gently reinsert the battery compartment cover.
REMOTE CONTROLLER OPERATION NOTES
When using the remote controller, aim the controller directly at the air condition-
ing unit's iR receiver located on the control
panel.
The remote controller must have a clear line of
sight to the control panel.
When the remote controller will remain unused
for long periods of time, please remove the bat-
teries.
If the display appears faint or does not appear,
please replace the batteries.

INSTALLING THE FILTER

Your air conditioner comes with a carbon filter to help remove any unwanted odor from
the room. It is recommended that you replace the filter every two to three months, or as
needed. It is also necessary to clean the filter periodically ( see cleaning instructions).
Follow the steps below to install the carbon filter.
1. If the unit is on, turn it off and wait three
minutes.
2. In the rear of the unit, open the air filter
grille cover from the side.
3. Place the carbon filter between the grille
and the pre-filter.
4. Close the grille.
IR signal transmitter
Battery compartment cover
–22–
–22–
Batteries
Close
Open

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido