Publicidad
EN
Declaration of conformity! This product complies with
the requirements of the valid EU Guidelines. The dec-
laration of conformity for this product can be requested
from the following address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
Technical data
– Power supply:
– max. Power consumption:
Prod. no.:
33296 XX1500:
33296 XX2000:
33296 XX2500:
33296 XX3000:
33296 XX3500:
– Protection rating:
– Ambient conditions:
Temperature
– Light colour
Mounting dimensions, see pages 2 and 3.
Modes
Circuit diagram, see fi gure 1 on page 18.
The device can be operated in two modes.
Mode 1 (ex works):
Lighting On/Off at the device button (Off automatically
after power returns).
Mode 2:
Lighting On/Off at the external light switch (Off
automatically after power returns).
To change mode, see table under Operation:
Installation, see fi gure 2 onwards on page 18.
6
Important information, please make sure to read!
230 V AC/ 50 Hz
Width
Weight
Light
500 mm
9.1 kg
27 W
650 mm
11.0 kg
30 W
800 mm
12.8 kg
33 W
1000 mm
15.4 kg
42 W
1200 mm
17.9 kg
48 W
IP20
5°– 40° C
3000 Kelvin
Button functions
Button Function
Light on/off
• Pressing the button switches the mirror on with the
selected settings. The white LED goes off.
• Pressing the button again switches the mirror off.
The white LED lights up.
To change mode
• Switch off the refl ector.
• Press the button and hold it down for 15 seconds.
- The light comes on again if the mode has been
changed.
Repeat the procedure described to re-enable mode 1.
• The white LED can be deactivated.
– Switch on the mirror.
– Press and hold the button for 10 seconds.
- The lighting goes off.
- A short light impulse indicates that the white
LED was deactivated.
To switch the white LED back on, repeat the de-
scribed procedure.
Front and wall lighting
• The front and wall lighting is switched on by press-
ing the button when mirror is switched on.
• Pressing the button again switches the light off.
Washbasin lighting
• The washbasin lighting is switched on by pressing
the button when mirror is switched on.
• Pressing the button again switches the light off.
When both lightings are switched off, the mirror also
switches off.
Dimming the front, wall and washbasin lighting
• Press the button when the mirror is switched on
and hold until the desired brightness or the end
value has been reached.
The setting is stored and reproduced when switched
on again (only for connection type 1, see fi gure 1 on
page 18).
Replacement parts with order numbers, see pages 22
and 23.
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
For information about warranty and maintenance, see
the enclosed Maintenance and Warranty Passport.
Disposal information! Equipment with this labelling
must not be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.
Publicidad
