AudioSonic HF-1255 Manual De Instrucciones página 5

LOCATION OF CONTROLS
1) CD DOOR
2) FM STEREO LED INDICATOR
3) CD PLAY/PAUSE
4) CD SKIP DOWN
5) CD SKIP UP BUTTON
6) CD STOP / BAND SELECT BUTTON
7) LCD DISPLAY
8) VOLUME UP BUTTON
9) VOLUME DOWN BUTTON
10) FUNCTION SELECTOR BUTTON
11) MP3 FOLDER UP BUTTON
12) USB SOCKET
13) 3.5MM HEADPHONE JACK
14) FM MONO / FM STEREO SELECTOR
15) CD DOOR OPEN BUTTON
16) REMOTE SENSOR
17) POWER STANDBY LED INDICATOR
18) POWER ON/STANDBY BUTTON
19) TUNING KNOB
20) CLOCK ADJUST / PRE-SET EQ BUTTON
21) SD/MMC CARD SLOT
22) DUST COVER
23) FM WIRE ANTENNA
24) SPEAKER WIRE CONNECTOR (L/R)
25) RCA AUX-IN JACK
26) AC POWER CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
IMPORTANT:
SINCE MOVEMENT OF THE CD MECHANISM AND THE SENSITIVE CIRCUITY MAY CAUSE INTERFERENCE TO THE
RADIO TUNER NEARBY, SWITCH THIS UNIT OFF WHILE OPERATING OTHER
PRECAUTIONS FOR USE
INSTALLATION
•
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
•
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAIN VOLTAGE AND BEFORE ALL OTHER
CONNECTIONS HAVE BEEN MADE.
•
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS AROUND THE
UNIT FOR VENTILATION.
CONNECTION
1. CONNECT THE POWER CORD (26) TO AC OUTLET
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE UNIT WILL GO INTO STANDBY MODE AND THE LCD
INDICATOR (7) WILL LIGHT UP, THE DISPLAY WILL SHOW "12 :00 " AND START FLASHING.
3. CONNECT THE SPEAKER WIRE TO THE SPEAKER TERMINAL (25) LOCATED ON THE REAR SIDE OF UNIT.
4. TURN ON THE POWER (18), IF THE LCD DISPLAY IS ON WITH BACKLIGHTING, IT MEANS THE POWER SUPPLY IS
NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
SETTING THE CLOCK
1. SET UNIT IN STANDBY MODE.
2. PRESS & HOLD THE "CLK-ADJ/PRESET EQ" BUTTON (20), THE DISPLAY WILL SHOW 12h OR 24h AND THEN
PRESS OR
3. PRESS " CLK-ADJ/PRESET EQ " BUTTON (20) AGAIN, THE FIRST SECOND DIGIT OF IS FLASHING. PRESS
BUTTON (4,5) TO SET THE CORRECT HOUR. PRESS " CLK-ADJ/PRESET EQ " BUTTON (20)TO STORE THE
CORRECT HOUR.
4. THE THIRD FOURTH DIGIT IS FLASHING, PRESS THE
THEN PRESS " CLK-ADJ/PRESET EQ " (20) TO STORE THE CORRECT MINUTE.
BUTTON
BUTTON
BUTTON (4,5) TO SELECT THE APPROPIATE AREA HOUR (12H/24H)
RADIO DEVICES.
OR BUTTON (4,5) TO SET THE CORRECT MINUTES.
GB-4
OR