Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA (continuation)
High Level Probe (NivOil HP)
Exclusively for connection to the sensor supply unit (NivOil CU)!
Material sensor
Cable
Cable colour
Dimensions
Protection
Measuring principle
Ambient temperature
EU Type Examination Certificate BVS 07 ATEX E 092 X
Ex-maximum values
Maximum input voltage Ui
Maximum input current Ii
Maximum input power Pi
Maximum internal capacity Ci
Maximum internal inductance Li
Ex marking
Interconnection
Special conditions for safe use
The connection line of the high level probe (NivOil HP) must be routed through the separation between areas with category 1G requirements
and less hazardous areas in such a way that protection class IP67 in accordance with EN 60529 is guaranteed.
The high level probe (NivOil HP) and the connecting cable may only be used in areas where there is no risk of electrostatic discharging.
Observe the technical information on the use of the high level probe (NivOil HP) in connection with aggressive/corrosive media.
EN
M-531.01-EN-AK du 30-06-2023 - Manufacturer : BAMO IER - Pirnaer Straße 24, D-68309 Mannheim - Germany (Translated document)
PE-EL with PTC stainless steel sensor
standard with 10m oil/petrol resistant cable 2x1mm²
Other cable lengths on request
Maximum permissible cable length: 300m
[C ≤ 200nF/km and L ≤ 1mH/km]
blue
ca. Ø32 x 200mm
IP68
PTC sensor, heated
-20°C...+60°C
17.9V DC
157mA
695mW
60nF
(no mixed parameters)
0.3mH
(no mixed parameters)
㐀 II 1G Ex ia IIB T3
(intrinsically safe electrical equipment)
Sensor supply unit (NivOil CU) with overfill probe (NivOil HP)
·
Publicidad
