Bose T4S ToneMatch Guia De Inicio Rapido página 10

System Setup
Connecting the T4S via Digital Connection
1. Make sure the L1 Model 1S/II and T4S are powered off and the T4S Master volume control is set to
minimum.
2. Plug one end of the ToneMatch® cable into the Power port/Digital Main Output R on the T4S. Plug the
other end of the ToneMatch cable into the ToneMatch port on the power stand.
Note: To connect the T4S to two L1 Model 1S/II power stands, connect a second power stand to the Digital
Main Output L port on the T4S using a ToneMatch cable.
3. Turn on the mixer and then turn on the L1 Model 1S/II power stand.
4. Connect your instruments and adjust levels. Refer to the complete owner's guide at www.Bose.com for
complete operation information.
Figure 9. Two L1 model II systems connected to a T4S via digital connection
Note: The T8S cannot be connected digitally and cannot be powered by the L1 Model 1S/II.
10 - English
MONO
USB AUDIO
M