Uline H-7630 Guía De Solución De Problemas

H-7630, H-7631
H-8226
PACKING STATION
OPERATING ISSUE
Accessory too short/doesn't fit between
uprights.
M8 hex bolts have varying size heads.
Tabletop is hard to drill through due to
clearance in step 2 of Top Assembly in
instructions.
Frame support bars are not fitting into legs.
Paint bubble blocking holes for bolts.
PAGE 1 OF 3
1-800-295-5510
uline.com
TROUBLESHOOTING
Ensure uprights are facing the right direction.
(See Upright Assembly in instructions)
13 mm or 14 mm open end wrench(s) may be needed.
Remove the storage shelf support brackets and re-attach after
drilling the holes.
Align the two and insert M8 x 65 hex bolts through the
legs and into the frame support bars. Start fastening the
M8 x 65 hex bolts to help bring support bars and legs together.
Insert bolt as far as it goes and start threading it through the
hole. Bolt will work its way through and break paint bubble.
Para Español, vea página 2.
Pour le français, consulter la page 3.
RECOMMENDATIONS
0523 TH-7630