Descargar Imprimir esta página

Bosch Professional GST 150 CE Manual Original página 14

Ocultar thumbs Ver también para Professional GST 150 CE:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
OBJ_DOKU-19156-001.fm Page 14 Thursday, September 3, 2009 9:12 AM
14 | English
Delivery Scope
Accessories shown or described are not part of
the standard delivery scope of the product. A
complete overview of accessories can be found
in our accessories program.
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
Technical Data
The technical data of the machine are listed in
the Table on page 109 of these operating in-
structions.
The values given are valid for nominal voltages
[U] of 220 – 240 V. For lower voltage and models
for specific countries, these values can vary.
Please observe the article number on the type
plate of your machine. The trade names of the
individual machines may vary.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
2 609 932 680 | (3.9.09)
Dr. Egbert Schneider
Dr. Eckerhard Strötgen
Senior Vice President
Head of Product
Engineering
Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
28.07.2009
Noise/Vibration Information
The technical data of the machine are listed in
the Table on page 109 of these operating in-
structions.
Noise and vibrational values (vector sum of
three directions) determined according to
EN 60745.
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Bosch Power Tools

Publicidad

loading

Este manual también es adecuado para:

Professional gst 150 bce