Descargar Imprimir esta página

Daewoo CCH V 1065 HY MF D Manual De Usuario página 61

Publicidad

Idiomas disponibles

Idiomas disponibles

The operating time will be calculated and
the oven will automatically start so that
cooking will finish at the set finishing time.
When the timer reaches zero, the oven will
switch off, an audible warning will sound
and the symbols "A" and
Turn both control knobs to the "0" position
and press any key to stop the sound. The
symbol will disappear and the timer will
switch back to manual function.
Sound Adjustment
To adjust the volume of the audible warning
sound, while the current time of day is
displayed, press and hold the "-" button for
1-2 seconds until an audible signal sounds.
After this, each time the "-" button is
pressed, a different signal will sound. There
are three different types of signal sounds.
Select the desired sound and do not press
any other buttons. After a short time, the
selected sound will be saved.
4.4 Accessories
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
6. Select the desired
finishing time using the
"+" and "-" keys.
7. Add the cooking
period to the current
time of day. You can
set a time of up to 23
hours and 59 minutes
after this.
8. The current time
will reappear on
the screen, and the
symbols "A",
and
will remain illuminated.
will flash.
5
4
3
2
1
• Insert the accessory to the correct
position inside the oven.
• Allow at least a 1 cm space between the
fan cover and accessories.
• Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
• The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
• Trays and wire grids can be positioned
on any level from 1 to 5.
• Telescopic rails can be positioned on
levels T1, T2, 3, 4, 5.
• Level 3 is recommended for single level
cooking.
• Level T2 is recommended for single
level cooking with the telescopic rails.
• The turnspit wire grid must be
positioned on Level 3.
• Level T2 is used for the turnspit wire
grid positioning with telescopic rails.
****Accessories may vary depending on the
model purchased.
The Deep Tray
The deep tray is best used for cooking
stews.
Put the tray into any rack and push it to the
end to make sure it is placed correctly.
The Small Tray
EN - 18
T2
T1

Publicidad

loading

Productos relacionados para Daewoo CCH V 1065 HY MF D