Publicidad
DC REMOTE CONTROL
RESET AND SYNC
1
2
Power on the receiver, press the central key at the
emitter at once. The learning is succeed, when hear
double beep ringing from the loudspeaker.
Disconnect the mains and
Encender el receptor y pulsar el botón central del mando
start the synchro process.
a la vez. Cuando se hayan sincronizado se oirá un doble
Desconectar la alimentación
pitido.
y empezar el proceso de
sincronización.
Stromversorgung
ausschalten und den
Synchronisierungsvorgang
starten.
Coupez l'alimentation et
lancez le processus de
synchronisation.
RF wireless digital transmission
technology is adopted to realize the
one-to-one control providing a rate of
coincident code les than 1/50000. Same
code number is attached to the back of the
emitter and the receiver.
In a sufficient space, you
When the emitter is unable to remotely
can use the receiver at
control the receiver, please check whether
any angle, no worry about
the switch batteries are in good contact,
the direction.
whether they are fixed properly and whether
they run out of use.
+
When the emitter is unable to remotely
control the receiver, please check
whether is other remote control
products around the space and check
whether the keys are pressed down.
Same nature of remote control product
may cause interference with each other
resulting in poor receiving effect. Taking
away such articles will normalize the
remote control function.
7 / 7
BEEP
Please take out the
batteries if you will
not use this product
for a long time.
Publicidad
