Nordcap COOL-LINE KT 9 1T-2Z Informacion General página 11

THERMOSTAT
The thermostat is placed in the control panel.
The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.
When turning on the cabinet the display will show the current temperature in the cabinet.
Display set temperature:
Press this key and the display will show the set temperature. Press the key again to
return to normal reading
Set new temperature:
Press this key continuously for more than 3 seconds and the display shows the set
temperature. (The '°C' LED is flashing)
Press this key to increase the set temperature.
Press this key to lower the set temperature.
Press this key to save the new settings. The display will flash with the new value and
will then return to normal reading.
Keyboard lock/unlock:
Press these keys simultaneously for 5 seconds. To lock the display reads 'PoF'.
To unlock the display reads 'Pon'.
Alarm codes:
Flashing in the display: indicates that the cabinet sensor is defective.
Flashing in the display: indicates that the evaporator sensor is defective.
CHANGING OF PARAMETERS
Ask table of parameters from Nordcap Service.
11