Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Risk of child entrapment. It is possible for children to
be trapped inside this cooler and suffocate. Keep cooler
out of the reach of children.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the product when you
are assembling parts, making adjustments, cleaning, or
when not in use. Removing battery pack will prevent acci-
dental starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Ensure that the drain plug is securely in place and the
product does not leak water when filling the cooler. Do
not overfill. Leaks can result in a slippery surface and
create a slip and fall hazard.
APPLICATIONS
You may use this product for the purpose listed below:
„ Portable cooling for sporting events and camping
„ Refrigeration or freezing in emergencies when power
outages occur
USING THE POWER COOLER
Before using the cooler in a remote location, load the cooler
and pre-chill its contents by using the 120V AC adaptor or
12V DC adaptor. Remove adaptor cord and insert the 18V
battery before transporting it to your remote destination.
OPERATION
CONNECTING TO THE POWER SUPPLY
See Figures 4-5.
Connecting to an 18V battery:
„ Securely close the cooler lid.
„ Lift the latch to open the battery compartment.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
„ Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
Connecting to an 120V AC power outlet:
„ Insert the AC power cord into the cooler power input.
„ Insert AC power cord plug into an electrical outlet.
Connecting to a 12V auto accessory power outlet:
NEVER use the cooler with any 12V DC power source that
uses a positive ground.
NOTE: Some vehicles require the ignition to be turned on
before power is supplied to an accessory outlet.
„ With the cooler turned off, insert the DC power cord into
the cooler power input.
„ Insert DC connector into your vehicle's accessory power
outlet.
NOTE: Set battery protection mode to H when the cooler is
connected to the 12V auto accessory port. M and L should
be set when the cooler is connected to a portable battery
or other battery back-up devices.
OPERATING THE COOLER
See Figure 6.
WARNING:
Only move the cooler by lifting the handle and pulling
the cooler on its wheels. Do not tilt or tip over appliance;
tilting or tipping unit can cause water to spill, resulting in
possible electric shock, slip and fall hazard, or property
damage.
WARNING:
Keep water away from all electrical devices to reduce the
risk of electrocution or electric shock.
„ Connect to the power supply.
„ The buzzer will make a long beep, and the display initial-
ization screen will turn on for two seconds before entering
standby mode.
„ Press the power button to turn the cooler on or off.
7 — English
Publicidad
