Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERIES REPLACEMENT
1. Turn the remote control over, and locate the battery cover.
2. Remove the battery cover by sliding it towards the bottom end of the remote control.
3. Insert two AAA batteries into the battery socket, the battery has two poles(positive and negative),
the flat side is negative pole, make sure the batteries are firmly seated into the remote control.
4. Reinstall the battery cover, making sure it clicks into position.
NOTE: Do not use old and new batteries together !
TROUBLESHOOTING
Fault code
E1
The heater overheating
E2
E3
The heater not working.
Battery Cover
Fault Cause
NTC is defective.
Call after-sales service.
Call after-sales service.
If the vents are dirty or clogged. Unplug the power,
clean the dust and debris of the vent area. Wait for 5
minutes, plug in and turn on the heater. If the heater
still don't work, please call after-sales service.
08
Solution
Publicidad
